Signal Boxes

To assist modellers plan and build a Caledonian Railway layout with the appropriate stock. A list/catalogue of supplies and components is available to members in the Association Resources section of the Forum below.
Post Reply
Orbiston
Posts: 36
Joined: Fri Jun 13, 2014 3:57 pm

Signal Boxes

Post by Orbiston » Thu Aug 01, 2019 2:52 pm

I have grown tired of trying to adapt proprietary models to look vaguely like CR signalboxes (and the Bachmann offering doesn't cut it for me) so I thought I would have a try at getting one cut using this new technology. I have used it for a McIntosh 50 foot open third and been very pleased at its potential. So with the welcome advice of Jim Mac and Jim Watt I have put this together. Its not meant to be the full kit and is slightly off original to allow the use of proprietary offerings like stairs, doors and lavatory, and readily available plastic mouldings for corners etc. I've already sourced the roof and walkway supports from York Modelmaking to use in an earlier abandoned kit bashing attempt. And I haven't attempted the roof as I'm aware that modellers have their own way of making roofs. I realise that my standards may be way below others but I'm hoping to produce a typical Southern Region Box. I'd welcome any comments.
Attachments
CR Signalbox shell.pdf
(4.13 KiB) Downloaded 266 times

jasp
Posts: 443
Joined: Mon Aug 20, 2012 5:40 pm

Re: Signal Boxes

Post by jasp » Thu Aug 01, 2019 8:16 pm

I am really pleased about your efforts.
Difficult to visualise from the drawings and I look forward to the result.
Anyone fancy doing a Northern Division box?
Jim P

jimwatt2mm
Posts: 633
Joined: Fri Nov 16, 2012 5:36 pm

Re: Signal Boxes

Post by jimwatt2mm » Thu Aug 01, 2019 8:18 pm

Only comment I would make is that you will need to extend the inner part for the door end to the full depth of the door. As it is, you will only get the top half of the door.

You can see how I did mine, as an etch, from here https://www.rmweb.co.uk/community/index ... nt=2933235.

Jim

Orbiston
Posts: 36
Joined: Fri Jun 13, 2014 3:57 pm

Re: Signal Boxes

Post by Orbiston » Sat Aug 03, 2019 5:16 pm

Thanks Jim,
you are absolutely right

Orbiston
Posts: 36
Joined: Fri Jun 13, 2014 3:57 pm

Re: Signal Boxes

Post by Orbiston » Mon Oct 28, 2019 1:53 pm

I had to amend the drawing as as drawn it is too flimsy for laser cutting. Slightly less proto but more practical. Amended drawing attached. I had hoped to attach photos of what you get when printed and some of the stock items I chose to use but the files are too big to attach. I realise I'm hopelessly unproductive but I'll try to get round to actually putting the thing together to see if there are any problems.
Attachments
CR Signalbox shell bis.pdf
(4.1 KiB) Downloaded 104 times

Post Reply